If a spring has broken on your warehouse, shop or loading dock door, stop using the door and call us. In Edmonton and Nisku we repair and replace commercial overhead door springs, and we can match the spring to how often your door really runs, so it does not break again in a year. We inspect the door, quote the work in writing and fit the new springs, usually in the same visit. Call 780-908-0907. We are open 24 hours a day, 7 days a week.
Commercial door springs hold a lot of stored force and the doors they lift are heavy. A broken spring can leave a door that is far heavier than it looks. Do not stand or walk under the door, do not try to lift or lower it by hand and do not touch the spring, the cones or the winding bars. Block off the opening, keep staff and vehicles clear and call a technician.
Signs a Commercial Door Spring Has Broken or Is Failing
| What you see or hear | What it usually means |
|---|---|
| A loud bang from the door, then it will not open | A torsion spring has broken |
| The door opens a little and stops, or the operator strains | The spring is gone and the operator is lifting the full weight |
| The door is heavy by hand, or drops when released | The spring is weak or broken |
| A visible gap in the spring coil | The spring has snapped |
| The door is crooked, or one side hangs lower | One spring has failed, or the springs are uneven |
| The operator trips, or burns out quickly | The operator is taking the load the springs should carry |
| The door has started to sag at the centre | Spring tension or the shaft is wearing |
A spring that sounds like a gunshot is the classic sign. In a busy yard, the first sign is often a door that will not open on a cold morning.
Why Commercial Door Springs Break
- Cycle life. A spring is rated for a number of open and close cycles. A standard spring is often rated for about 10,000 cycles. A door that runs 20 times a day reaches that in about two years.
- Cold. Springs and the steel around them get stiff and brittle in a deep freeze, and many fail on the first cycle of a cold morning.
- Rust. Condensation, road salt and moisture on springs let rust eat the surface, which starts cracks.
- Wrong spring. A spring chosen only by length, and not by wire size, diameter and door weight, is overworked from day one.
- A heavier door. Added insulation, a replaced section or water in a wooden door can make the door heavier than the springs were set for.
- No maintenance. Dry, unchecked springs wear faster.
- One spring replaced. A new spring next to an old one carries more of the load, and the old one is not far behind.
How Many Cycles Does Your Door Need?
Spring life is a math problem you can do in a minute.
- Estimate cycles per day. One open and one close is one cycle.
- Multiply by the days your door runs each year. A weekday business is about 250 days.
- Multiply by the years you want the spring to last.
| Cycles per day | Cycles per year (250 days) | Lasts about, with a 10,000-cycle spring | Lasts about, with a 50,000-cycle spring |
|---|---|---|---|
| 5 | 1,250 | 8 years | 40 years (other parts wear first) |
| 20 | 5,000 | 2 years | 10 years |
| 50 | 12,500 | Under 1 year | 4 years |
| 100 | 25,000 | A few months | 2 years |
High-cycle springs use heavier wire or a larger coil and are made for doors that run all day. They cost more up front, and one avoided breakdown on a busy dock often pays the difference. We help you work out the rating you need and quote it.
Commercial Door Spring Types We Repair
- Torsion springs on sectional doors. The most common type. One or two springs sit on a shaft above the door, with cables and drums. This is where most commercial spring work happens.
- Springs on high-lift and vertical-lift doors. These doors use more drums and often more springs to lift sections along a longer path.
- Counterbalance springs on rolling steel doors. The spring sits inside the barrel that the curtain rolls on. See our commercial overhead door service for rolling steel doors.
- Extension springs on lighter doors. Found on some smaller doors and older buildings. We often recommend replacing them with a safer system when the door is due for an upgrade.
If you are not sure which type you have, send us a photo or call and we will tell you.
What to Send Us for a Quote
- Photos of the whole door and the spring area.
- Door size and type. Width, height and whether it is a sectional, rolling steel or other door.
- How often it runs. Cycles per day, or how many people use it.
- What happened. A bang, a stuck door or a slow decline.
- Any marks on the spring. Many springs have a cone with a tag or a colour mark.
We confirm the rest on site, because a spring is chosen by the door’s weight and not just by what the old one looked like.
How We Replace Commercial Overhead Door Springs
- Make the area safe. We close off the opening and secure the door.
- Inspect the whole door. A broken spring often leaves a worn cable, drum, bearing or bracket. We check all of them.
- Weigh and match. We work out the right spring for the door’s weight, size and cycle needs.
- Quote it in writing. You see the price, including a high-cycle option when it makes sense, before we start.
- Replace the springs. We replace springs in pairs and set the tension with the right tools and bars.
- Balance and test. We check the door’s balance by hand, run it on the operator and test the safety devices.
- Give you a record. We tell you what we found and what to watch next.
Commercial Door Spring Repair Cost in Edmonton
Commercial door spring work is quoted after an assessment, because the price depends on the door and the spring. Here is what changes it:
| What affects the price | Why it matters |
|---|---|
| Door size and weight | Larger doors need bigger springs |
| Number of springs | Some doors have two, some have four or more |
| Cycle rating | A high-cycle spring costs more than a standard one |
| Door type | Sectional, rolling steel and high-lift doors have different parts |
| Other worn parts | Cables, drums, bearings and brackets add to the job |
| Time of day | After-hours calls are priced when you call |
| Access | A door in a high bay or at a busy dock takes more time |
Our quote is written and fixed before we start the work.
Can You Wait? What to Do Until We Arrive
If a spring has broken, treat the door as unsafe until a technician checks it.
- Keep people and vehicles away from the opening.
- Do not run the operator. It can burn out and strip the door’s drive.
- Do not lift the door by hand. It may be heavy and can drop.
- Block the doorway with a cone, a barrier or a parked vehicle that is not under the door.
- If the door is stuck open, call us right away. An open door is a theft and a freezing risk, and we can arrange to secure it.
For a door that is stuck and cannot wait, see our emergency garage door repair information.
Cold, Salt and Heavy Use: Why Edmonton Is Hard on Commercial Springs
- A deep freeze makes springs brittle. The first cycle on a morning at minus 30 is when many fail.
- Road salt and slush rust the surface. Docks and yards get the worst of it.
- Doors left open lose heat and let in moisture. The cycle of freeze and thaw wears steel faster.
- Winter cuts operating hours, but not cycles. Doors still run all day.
We suggest a fall inspection of every busy door. See the cycle based schedule on our commercial overhead door service page. A spring inspection costs a fraction of an emergency call.
Related Commercial Door Services
A failed spring often points to other worn parts.
- Commercial overhead door cable repair
- Commercial overhead door opener repair and installation
- Commercial garage door maintenance
Looking for a house door? See our broken garage door spring service.
Commercial Spring Repair Across the Edmonton Region
We repair commercial overhead door springs in Edmonton, Nisku, Fort Saskatchewan, St. Albert, Sherwood Park, Spruce Grove, Leduc and Beaumont.
Why Edmonton Businesses Call Fix in Budget
- We match the spring to your door. We work out the weight and cycle needs, not just copy the old part.
- Written quote first. You approve the cost before we start.
- Whole door check. We look at the cables, drums, bearings and operator, not only the spring.
- Planned service. We can set up a schedule based on how often each door runs.
- Residential and commercial. One company for the shop and for the house.
- Open 24/7. If a door fails at night or on a weekend, we can help.
Commercial Door Spring Repair FAQs
How much does commercial garage door spring replacement cost in Edmonton?
The price depends on the door size and weight, the number of springs and the cycle rating. We quote it in writing after we assess the door, and we confirm it before we start. A high-cycle spring costs more up front but lasts longer on a busy door.
How long do commercial overhead door springs last?
It depends on cycles, not years. A standard spring is often rated for about 10,000 cycles, which a door that runs 20 times a day uses up in about two years. High-cycle springs are rated for 25,000, 50,000 or more.
Should I replace one spring or both?
Both. A new spring next to an old one makes the old one carry more of the load, and it usually fails soon after. We replace springs in pairs.
What is a high-cycle spring?
It is a spring made with heavier wire or a larger coil, so it can run more open and close cycles before it wears out. It suits doors that run many times a day, such as loading docks and service bays.
Can I use my commercial door with a broken spring?
No. The door is heavier than it looks and can drop, and the operator can burn out trying to lift it. Keep people clear and call a technician.
Why do commercial door springs break in winter?
Deep cold makes springs and nearby steel brittle, and many fail on the first cycle of a cold morning. Rust from salt and moisture also starts cracks. A fall inspection can catch a weak spring first.
Can you repair a spring on a rolling steel door?
Yes. Rolling steel doors have a counterbalance spring inside the barrel. We inspect and replace it as part of our commercial door service. Call us with the door size and a photo and we will confirm.
Do you offer emergency commercial spring repair in Edmonton?
Yes. We are open 24 hours a day, 7 days a week. If a door is stuck open or will not move, call us and we will secure the opening and arrange the repair.
Call Fix in Budget for Commercial Overhead Door Spring Repair in Edmonton
Send us a photo of the door and the spring area, and tell us how often the door runs. We will tell you what we need and how fast we can be there. Call 780-908-0907 or request a quote. We are open 24 hours a day, 7 days a week.
